The Standards Committee that approved the code or standard was balanced to assure that individuals from competent and concerned interests have had an opportunity to participate. This code or standard was developed under procedures accredited as meeting the criteria for American National Standards. Cases are published on the ASME Web site under the Committee Pages at as they are issued.ĪSME is the registered trademark of The American Society of Mechanical Engineers. Periodically certain actions of the ASME Y14 Committee may be published as Cases. There will be no addenda or written interpretations of the requirements of this Standard issued to this edition. This Standard will be revised when the Society approves the issuance of a new edition. Approved for public release distribution is unlimited.Įngineering Drawing and Related Documentation Practices Since organizations and responsibilities can change, you shouldverify the currency of the information above using the ASSIST Online databaseat. NOTE: The activities listed above were interested in this document as of the dateof this document. Review Activities:Army CR, IE, MI, PT, TM2Navy AS, CG, CH, EC, MC, NP, TDAir Force 13, 99DLA DHOSD SENSA NSOther CM, MP, DC2
Ĭustodians: Adopting Activity:Army AR Army ARNavy SA (Project DRPR-2009-003)Air Force 16 Copies of this document may be purchased from The American Society of MechanicalEngineers (ASME), 22 Law Drive, P.O. Army Research, Development and Engineering Center (ARDEC), ATTN: AMSRD-AAR-QES-E, PicatinnyArsenal, NJ 07806-5000.
Proposed changes by DoD activities must be submitted to the DoDAdopting Activity: Commander,U.S.
Not for Resale, 05:54:39 MSTNo reproduction or networking permitted without license from IHS A N I N T E R N A T I O N A L S T A N D A R DĪSME Y14.5-2009ĭimensioningand TolerancingEngineering Drawing and Related Documentation PracticesĬopyright ASME International Provided by IHS under license with ASME Licensee=FMC Technologies /5914950002, User=Souza, Arthur
0 kommentar(er)
